Front Panel Removal And Installation; Remote Controller Installation - Fujitsu ASU15RLS3Y Manual De Instalación

Overlap the insulation
Connection pipe
(heat insulation)
Bind the pipes together
so that there is no gap.
Pipe
Drain hose
Left piping
Connection cable
Pipe
Drain hose
Seal A is used when the diam-
eter of gas pipe is Ø12.70 or
more.
Butt connection pipe (heat
insulation) against the indoor
unit pipe (heat insulation) and
wrap with Seal A so that there
is no gap.
Check the following:
GOOD
Drain hose
Saddle

8. FRONT PANEL REMOVAL AND INSTALLATION

Intake grill removal
Open the intake
grille. While gently
pressing the left
and right mounting
a
shafts of the intake
b
grille outward "a",
remove the intake
grille in direction of
the arrow "b".
8.1. Front panel removal
(1) Remove intake grille (Reference the intake grille removal.)
(2) Remove 3 caps.
(3) Remove wire cover.
(4) Remove 7 screws.
Diffuser
NOTE: When replacing the front panel, do not scratch or damage the diffuser.
(5) The front panel is pulled to the front, raising the upper surface, and a front panel is
removed.
9320456030_IM.indb 7 9320456030_IM.indb 7
Indoor unit pipe
(heat insulation)
Vinyl tape
Wrap with cloth tape
Cloth tape
For connection from the left rear
Wall pipe Connection cable
Drain hose
Connection pipe
PROHIBITED
Lifted up Wave End in water
Intake grill installation
While holding the
grille horizontal, set
the left and right
mounting shafts into
the pillow blocks at
the top of the panel
c
"c".
To latch each shaft
properly, insert the
shaft until it snaps.
Press 4 places on
the intake grille to
close it completely.
Screws (Wire cover)
Wire cover
Screws ( 7 position )
Caps ( 3 position )
Front panel
8.2. Front panel installation
(1) First, fi t the lower part of the front panel, and insert top and bottom hooks. (3 top
sides, 2 center)
Top holes (3 position)
Center hooks
(2 position)
Indoor unit
(2) Attach the 7 screws.
(3) Attach the wire cover.
(4) Attach the 3 caps.
(5) Attach the intake grille.
CAUTION
Install the Front panel and Intake grille securely. If installation is imperfect, the Front
panel or Intake grille may fall off and cause injury.

9. REMOTE CONTROLLER INSTALLATION

• Check that the indoor unit correctly receives the signal from the remote controller, then
install the remote controller holder.
CAUTION
• Select the remote controller holder selection site by paying careful attention to the
following:
Avoid places in direct sunlight.
Select a place that will not be affected by the heat from a stove, etc.
9.1. Remote controller holder installation
 Install the remote controller a maximum distance of 22 ft. (7 m) from the remote control
receiver. However, when installing the remote controller, check that it operates cor-
rectly.
 Install the remote controller holder to a wall, pillar, etc. with the tapping screw.
remote controller
holder fi xing
Remote
controller holder
Tapping screw
(small)
Top hooks
(3 position)
Front panel
Latches (2 position)
remote controller
mounting
1 Set
2 Push
Remote
controller
En-7
3/18/2016 6:14:34 PM 3/18/2016 6:14:34 PM