Publicidad
MagicTouch MT350
To replace the batteries, proceed as follows:
➤
Remove the screw under the hand transmitter and open the transmitter.
➤
Replace the battery.
Make sure that the polarity is correct when you insert the battery (battery type
CR2032 3 V). The positive terminal is at the top.
The battery is available e.g. in photo shops, clock shops, etc.
➤
Refit the lid on the hand transmitter and re-insert the screw.
8.5
Programming the remote control
MagicTouch can be operated using up to five hand transmitters. If a sixth hand trans-
mitter is programmed, MagicTouch deletes the first; a seventh deletes the second
etc.
Proceed as follows to program a new hand transmitter:
➤
Use a hand transmitter to open the vehicle.
➤
Sit down in the vehicle.
➤
Close all doors without locking them.
➤
Switch on the ignition.
➤
Now press both blue buttons simultaneously on a functioning hand transmitter
until the central locking system locks the vehicle.
✓
The system is now in programming mode.
Note
I
If you do not press a button within 10 seconds, you exit programming mode.
➤
Press one of the three buttons of the new hand transmitter until the central
locking system is opened for confirmation of the new code.
➤
Test the new hand transmitter.
➤
If the new hand transmitter does not work, repeat the previous worksteps.
8.6
Deleting a hand transmitter
You can disable a hand transmitter, e. g. if it has been lost, from use with your radio
remote control by re-coding the hand transmitters that may still be used.
➤
Recode these hand transmitters five times in succession by programming them
as described in chapter "Programming the remote control" on page 63.
9
Maintaining and cleaning MagicTouch
Caution!
a
Do not use sharp or hard objects to clean the device as these may damage
the components.
Maintaining and cleaning MagicTouch
63
Publicidad
