Publicidad
2
Carefully lift tunnel
assembly and position it
at the desired location
making sure it is level.
Press firmly for 10
seconds at each clip
location along the
length of the assembly
to secure the clips
and clip
23
the wall.
18
3
23
25
24
to
24
23
Peel the tunnels
25
away from
the clips
23
and
.
24
25
4
23
Arrange cables on either
side of the clips. Reattach
tunnels
25
and clip
the cables behind them.
Press firmly along the
24
length of the tunnels where
the clips are located until
clips snap in place.
NOTE: Leave enough
slack in the cables above the tunnel
to prevent them from interfering with
or rubbing against the tunnel when
25
moving the TV. This could cause the
tunnel to separate from the clips.
TIP: Use tape the hold the cables
in place during install.
25
to clips
23
, capturing
24
Publicidad
