AERMEC FCLI 32 Manual Instalación Y Uso página 26

INSTALLING THE "MODULE 840" UNIT
- Choose the place for unit installation
according to the layout of the room, the
number of units to be installed, and any
limitations imposed by the architecture.
Check the chosen place is suitable for
installation and maintenance work on
the unit.
- Install four M8 threaded rods into the
ceiling to hold the frame.
To install the FCLI unit, proceed as follows:
- open the cardboard box
- upturn the box of the FCLI cassette-type
fan coil
- remove the box
- remove the packaging shells used to
protect the unit during transport
- fix the 4 installation brackets to the unit
(see the figure)
- if it is necessary to fit any accessories
(electric heaters, kit for fresh air or
delivery to an adjacent room, hot water
valve), carry out these operations before
installing the machine on the ceiling
WARNING: consult the relevant manuals of
the accessories
- Do not handle the
unit using the water connections; use the
specific brackets for this purpose.
- lift the unit carefully by means of the
brackets and, keeping it slightly inclined,
attach it to the 4 threaded bars using 8
nuts (4 of which are self-locking). Use
the nuts to adjust the height of the unit;
finally, check that the unit is installed in a
horizontal position
- feed the hydraulic pipes through the
suspended ceiling to the attachment
plate on the unit
- make the plumbing connections as
described in the relative chapter
- Take the condensate discharge piping to the
relative fitting on the attachment plate
- m a ke t h e c o n d e n s a t e d r a i n a g e
connection as described in the relative
chapter
- drain the system; the drain valves are on
the outside, on the attachment plate
- bring the power supply and command
cables close to the electric box; ensure
the cables are long enough to follow
the movement of the electric box on
the guides during the assembly and
26
disassembly phases
- The electric box is supplied with the grille
accessories (GLLI20)
- consult the manuals of the grille
a cces s ori es ; t h e in stru cti o ns for
assembling and connecting the electric
box can be found in the manual supplied
with the accessory
- After completing the connections and
inserting the electric box in its seat in the
FCLI unit, fix it with the two screws.
- The grille frame must be positioned so
that the glass with the AERMEC logo is in
line with the corner of the electric box.
- Fix the grille with the 4 screws.
WARNING!! Tighten the screws with a
maximum tightening torque of 0.45 Nm.
You are advised to use a screwdriver.
Do not use non-calibrated electric
screwdrivers. The tray will be irreparably
damaged if tightened too far.
WARNING: fix one snap-hook of the safety
wire to the grille frame, and the other to
the fan protection grille.
Fasten the suction grille to the safety
wire.
- adjust the position of the unit from the
support bracket - by means of the nuts
- so the unit is level and the frame rests
slightly on the suspended ceiling
- Start the fan coil unit and carry out a
function test, the functions are described
in the user manual.