Use; Emptying Of Containers; Handling After Usage And Storage; Servicing - IPC Gansow 510 M Manual De Instrucciones

GB
To adjust the worn main sweeping roll or to use the
machine on a non-flat ground, simply rotate the wheel
(Picture 4 pos. 1) clockwise or counterclockwise to the
requested height.
N.B.: A clockwise (+) rotation of the wheel lowers
the brush to the floor; a counterclockwise (-)
rotation lifts it.
N.B.: Before adjusting the central brush, some
models require the loosening of the collar
Simply push the manual sweeper on the flooring where
there is dirt to eliminate.
N.B.: Remember that the number of revolutions of
sweeping rolls (thus, efficiency) depends on
the speed of travel.
To empty the main container, simply take it by the handle
and lift it upwards, withdrawing it from lateral guides
(Picture 6 pos. 1).
N.B.: Before removing the main container, in some
models it is necessary to release it by lifting
the lever (Picture 6 pos. 2) and rotating it at

HANDLING AFTER USAGE AND STORAGE

To avoid damaging lateral brush bristles, lift the brush
from the ground after every usage of the sweeper
(Picture 9 pos. 1).
In this way, during rest intervals, bristles are not
constantly under pressure and do not loose efficiency
This manual sweeper does not require servicing.
Dry clean only.
CENTRAL BRUSH
- Completely remove dirt containers.
- Lay the sweeper on its side so as to reach the central
brush with ease.
- Unscrew the 4 fastening screws (Picture 10 pos. 1).
- Withdraw the central brush as described in Picture 11.
- Assembly the new brush following the above-
mentioned stages backwards.

USE

EMPTYING OF CONTAINERS

SERVICING

REPLACEMENT OF BRUSHES

(Picture 4 pos. 2). After adjusting, tighten
hard.
To adjust the lateral brush, simply lift it to the rest
position and rotate the rubber element (Picture 5 pos.
1) clockwise or counterclockwise by hand after
releasing the collar (Picture 5 pos. 2).
N.B.: Like the above-mentioned brush, a clockwise
rotation lowers the lateral brush, while a
counterclockwise rotation lifts it.
Attention: Strings, wires, packing tapes and objects
with similar lengths should be collected
by hand. Remove them if they get rolled
onto the brushes.
90°. After this operation, bring the lever back
to its initial operating position.
To empty the back container, release the lock (Picture
7 pos. 1) and withdraw it at the back. Avoid turning the
opening downwards (Picture 8 pos.1).
Then, reassembly the containers in the proper position.
in cleaning when used.
If it is necessary to put the sweeper in limited spaces,
simply unscrew wheels and bend the handle forward to
a horizontal position (Picture 9 pos. 2).
Retighten wheels and store the product.
Do not wash the machine with water or solvents.
LATERAL BRUSH
- Lift the brush support arm to a vertical position.
- Unscrew fastening screws (Picture 12 pos. 1) and
remove the worn brush.
- Reassembly the new brush following the above-
mentioned stages backwards.
N.B.: After installing new brushes, check their
height. If necessary, adjust them.
- 6 -