Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
POWER TOOL
Model
No-load speed (Low/High)
No-load impact rate (Low/High)
Brick
Drilling
Wood
Capacity
Metal
Machine screw
Driving
Wood screw
Rechargeable battery (FEB12S)
Weight
CHARGER
Model
Charging time
Charging voltage
Weight
STANDARD ACCESSORIES
1 Plus driver bit (No. 2 × 55L) ......... 1
2 Charger (UC12SD) .............................. 1
DV12DV
3 Plastic case .......................................... 1
4 Hook ..................................................... 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES ...... (sold separately)
1. Battery (FEB12S)
2. Drill bit for brick
Diameter, 6.5 mm, 8 mm, 9.5 mm, 10 mm
Optional accessories are subject to change without
notice.
APPLICATIONS
Drilling of brick and concrete block, etc.
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.
0 – 350/0 – 1250 min
0 – 5250/0 – 18750 min
Steel: 10 mm, Aluminum: 10 mm
5.1 mm (diameter) × 32 mm (length) (Requires a pilot hole)
UC12SD
Approx. 1 hour (at 20°C)
12 V
1.4 kg
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the impact drill, charge the battery as
follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in
the battery until it comes into contact with the
bottom surface. (See Figs. 1 and 3.)
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the receptacle and check the
battery mounting condition.
About 1 hour is required to fully charge the battery
at a temperature of about 20°C. The pilot lamp goes
off to indicate that the batterry is fully charged.
The battery charging time becomes longer when a
temperature is low or the voltage of the power
source is too low.
When the pilot lamp does not go off even if more
than two hours have elapsed after starting of the
charging, stop the charging and contact your
HITACHI AUTHORIZED SERVICE CENTER.
DV12DV
–1
(/min)
–1
(/min)
10 mm
18 mm
6 mm
Ni-Cd battery, 12 V
1.9 kg
English
6
Publicidad
Tabla de contenido
