Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10.
If the A Logic was selected, the board begins to count the
pause time (max 10 min) and, after the required time has
elapsed, give an OPENING pulse to continue the procedu-
re. Otherwise, if you have selected the EP logic, the leafs
close immediatly as shown in next point.
11.
Leaf 2 (if present) starts the closing movement an the board
begins to count the delay of the leaf at closing.
12.
After the required time has elapsed, give an OPEN pulse
to make leaf 1 start the closing movement.
13.
Leaves 1 and 2 (if present) stop when they reach the closing
mechanical stop.
14.
Wait for LEDs LD4 and LD5 to go OFF, which means that the
SETUP procedure has finished.
When the SETUP procedure has been started,
if the leaves at point 4 and 5 open instead of
closing, the motor power supply cables must
be changed over.
When using the MANUAL SETUP , the slow-down
spaces, and leaf delays at opening are preset
by the board and cannot be modified. However,
delay at leaf closing and pause time can be
programmed during learning.
7 INSTALLATION OF BUS ACCESSORIES
This board is supplied with a BUS circuit enabling easy con-
nection of a high number of BUS accessories (e.g. up to 16
photocells pairs), appropriately programmed, using only two
cable without polarity.
Below we describe the addressing and memory storage of
the BUS photocells.
For other future accessories, refer to the specific instructions.
7.1 ADDRESSING THE BUS PHOTOCELLS
Important: the same address must be given to
both transmitter and receiver.
Make sure that there are no two or more
photocells pairs with the same address.
If no BUS accessory is used, leave the BUS con-
nector free (J10 - fig. 1).
A maximum of 16 BUS photocell pairs can be connected to
the board.
The photocells are split into groups:
Opening photocells:
Closing photocells:
Opening /Closing photocells:
Photocell used as an OPEN pulse:
Fig. 2 shows a 2-swing leaf automated system indicating the
coverage beams of the photocells:
A:
B:
C: Photocells with OPENING action
D:
Table 3 shows the programming operations of the dip-switch
inside the transmitter and of the BUS Photocells receiver.
Tab. 3 - Addressing of BUS Photocells
max 6
max 7
max 2
max 1
5
Photocells with OPENING and CLOSING action.
Photocells with OPENING action
Photocells with CLOSING action
Dip1
Dip2
Dip3
Dip4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
ON
ON
ON
ON
OFF
OFF
OFF
ON
OFF
OFF
ON
ON
OFF
ON
OFF
ON
OFF
ON
ON
ON
ON
OFF
OFF
ON
ON
OFF
ON
ON
ON
ON
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
ON
ON
ON
Fig. 2
Ref.
Type
B -C
OPENING
D
CLOSING
OPENING and
A
CLOSING
/
OPEN PULSE
Publicidad
Capítulos
Tabla de contenido
