Vertical Steam; Multiple Descaling System; Anti-Drip System - Bosch TDA 76 Serie Instrucciones De Uso

Vertical Steam

Do not iron clothing while it is being
worn!
Never direct the steam at persons or
animals!
Interval between shots should be 5
seconds.
Wait 10 seconds after each 4 shot cycle.

Multiple descaling system

(7)
Depending on the model, this range is
equipped with the "AntiCalc" (=component
1 + 2 + 3).
1. self-clean
Each time you use the steam regulator, the
"self-clean" system cleans the mechanism
of scale deposits.
2. calc'n clean
The "calc'n clean" function helps to
remove scale particles out of the steam
chamber. Use this function approximately
every 2 weeks, if the water in your area
is very hard.
1. Unplug the iron from the mains socket,
set the steam regulator to the
and fill the water tank with water.
2. Set the temperature selector to the
"max" position and plug in the iron.
3. After the necessary warm-up period,
the pilot light goes out. Then, unplug
the iron.
4. Hold the iron over a sink. Press the
"clean" button and gently shake the
iron. Boiling water and steam will come
out, carrying scale or deposits that
r
might be there.
5. When the iron stops dripping, release
the button, plug the iron in and heat it
up again until the remaining water has
evaporated.
6. Repeat the process if the iron still
contains impurities.
3. anti-calc
The
designed to reduce the build-up of scale
produced during steam ironing, helping
to extend the useful life of your iron.
Nevertheless the "anti-calc" cartridge
cannot remove all of the scale that is
produced naturally over time.
"anti-calc" cartridge
(6) "SensorSecure"
The "SensorSecure" function switches
off the iron when the handle is no longer
gripped, thus increasing safety and saving
energy.
After plugging in the appliance, this
function will be inactive for the first
two minutes while the iron heats up to
the set temperature.
Immediately after releasing the handle of
the iron, the pilot light at the front of the
handle will start flashing, indicating that
the iron is about to switch itself off.
If the iron handle is not gripped again
within ١٠ sec. it will shut off automatically.
When the handle is gripped again, the iron
will automatically switch itself back on and
will start heating again. The pilot light at
the front of the handle will stop flashing
and will show a continuous light.
Important:
If the iron is left unattended for more
than ten minutes, once the handle is
momentarily
again, the initial two minute heat up
process will start again.
position

Anti-drip system

(Depending on model)
If the temperature is set too low, the steam
is automatically switched off to avoid
dripping.
Fabric-protection soleplate
cover / blanket
(Depending on the model)
The fabric-protection is used for steam-
ironing delicate garments at maximum
temperature without damaging them.
Use of the protector also does away with
the need for a cloth to prevent shine on
dark materials.
It is advisable to first iron a small section
on the inside of the garment to see if it is
suitable.
has been
To attach the fabric protector to the iron,
place the tip of the iron into the end of the
fabric protector and press the rear of the
protector upward until you hear a click. To
release the fabric protector, pull down on
the clip at the rear and remove the iron.
en
or continuously gripped
(9)
(10)
(8)
11