Warnings For Use - AUtec E16 Serie Manual De Usuario

!
.
VISUALLY FOLLOW all movements of the machine and its load re-
maining inside the typical working range of the radio remote control.
BE POSITIONED in a way that permits him to see the "machine + ra-
dio remote control" system, and above all the load, in the best pos-
sible way.
Before using the radio remote control ALWAYS MAKE SURE that the
STOP pushbutton can be pressed and released: if it does not work,
do not use the radio remote control.
SWITCH OFF the transmitting unit when work is interrupted. Avoid
leaving the load suspended in the air (even when changing the bat-
tery).
NEVER LEAVE the transmitting unit unguarded when the starting
keyswitch is inserted.
SWITCH ON OR USE the transmitting unit only when starting work:
improper use could be hazardous.
NEVER SWITCH ON OR USE the transmitting unit in closed spaces,
with the machine not in sight, or outside the typical working range.
PRESS immediately the STOP pushbutton in case of hazard.
PAY ATTENTION to the entire work area. Press the STOP pushbutton
in case of hazard.
PAY ATTENTION not to let elements such as cement, sand, lime, etc.
deposit on the transmitting unit because they can compromise
transmitting unit use and safety.
In case of faults and/or damaged and/or faulty parts, PUT the radio
remote control out of use until the problem has been completely
eliminated.
Page 24 of 80

4 WARNINGS FOR USE

THE OPERATOR
MUST ALWAYS
4 - Warnings for use LIESNMU4