AUtec E16 Serie Manual De Usuario página 32

SWITCHING OFF
The transmitting unit should be
switched off each time work is
stopped by turning the starting
key to "O" and extracting it (al-
ways put the key in a safe place).
The transmitting unit may also switch
off automatically if the battery is not
sufficiently charged and/or when the
radio remote control is not used for
more than 3.5 minutes (set DIP nr. 1:
refer to paragraph 8 "Program-
ming").
!
The STOP pushbutton should be used when it is necessary to
stop the machine immediately when a dangerous condition
should occur.
To stop the machine immediately, press the STOP pushbutton.
To start working again, after having made sure that the working conditions are
safe, turn the STOP pushbutton in the direction indicated to deactivate it and re-
peat the starting procedure.
Page 28 of 80
To recharge a flat battery, proceed as
follows:
1. Insert the battery into its proper bat-
tery charger, which should be posi-
tioned in an area with a temperature
between +5°C e +45°C: The battery
now starts charging, a state signalled
by the lighting up of the "ON CHARG-
ING" pilot light.
2. After a maximum of 4 -5 hours the
"END OF CHARGE" light switches on:
the battery is fully charged. Remove
the battery from the charger (if the bat-
tery is not removed, charging contin-
ues in maintenance mode).
STOP
6 - Transmitting unit operation
BATTERY
LIESNMU4