Maintenance And Cleaning; Information About Recycling And Disposal - Parkside PFDS 33 B4 Instrucciones De Funcionamiento

Using the device / Maintenance and cleaning / Information about recycling and disposal
T
Welds on an inner edge
The preparation for this weld joint is very
simply and is carried out for thicknesses of 5
mm. The dimension "d" needs to be reduced
to a minimum and should always be less
than 2 mm.
U
Bei stärkeren Materialien ist sie jedoch nicht mehr
However, it is no longer expedient for thicker
materials. In this case, it is better to prepare
a joint as shown in Figure V, in which the
edge of the plate is angled.
V
Overlap welds
The most common preparation is that with
the straight weld edges. The weld can be
released using a standard angle weld seam.
Both workpieces must be brought as close to
each other as possible.
44 GB/NI/IE
W
z Maintenance and cleaning
Please note: The welding device must be
regularly serviced and overhauled for proper
function and for compliance with the safety
requirements. Improper and wrong opera-
tion may cause failures and damage to the
device.
† Switch off the main power supply and
the main switch of the device off prior to
performing any maintenance or repair
work on the welding device.
† Clean the interior and exterior of the
welding device regularly. Use com-
pressed air, cotton waste or a brush to
remove dirt and dust on the inside.
† In case of a defect or a necessary
replacement of equipment parts,
please contact the appropriate qualified
personnel.
z Information about recycling
and disposal
Don't throw away – recycle!
Please return this device, accessories
and packaging to your local
recycling depot.
Do not dispose of the inverter welding
device in household waste, in fire or in
water. Devices that are no longer functional
should be recycled wherever possible.
Ask your local stockist for advice.