Selecting The Input Source; Selecting The Last Source; Adjusting The Volume; Muting The Sound - HP MediaSmart SL4782N Guía Del Usario

For a list of the available buttons for:
Media feature, see "Using the Media
Main Menu" on page 83.
Media Center Green Start button features, see
"Using the Media Center Green Start Button" on
page 44.
For a list of the buttons available to operate a
programmed device, see "Operating a DVD Player or
Other Device" on page 46.
Selecting the Input
Source
1
Press the Source button on the remote control, or
on the TV, to open the list of input sources.
2
Press the Up or Down Arrow button on the
remote control, or press the Channel buttons
on the TV, to select the input source to view.
3
Press OK on the remote control, or press Select on
the TV.
Or
Press the Source button again to close the list of
input sources without changing the source.
The list of input sources identifies a connector set on
the rear of the TV:
Antenna or Cable is the ANT/Cable In
connector. The label shows the scan source
selection (Antenna or Cable) of the last channel
scan performed by either the Setup Wizard or the
Channel menu.
AV1 is the Standard Definition Input AV Input 1
connector set of S-Vid or Video.
AV2 is the Standard Definition Input AV Input 2
connector set of S-Vid or Video.
Component 1 is the Component High Definition
Input 1 connector set.
Component 2 is the Component High Definition
Input 2 connector set.
HDMI 1 is the Digital High Definition Input
connector HDMI 1.
HDMI 2 is the Digital High Definition Input
connector HDMI 2.
40
HP MediaSmart HDTV User Guide
HDMI 3 is the Digital High Definition Input
connector HDMI 3.
PC is the PC Input (VGA) connector set.
MediaSmart shows the Media main menu as if
you pressed the Media button.
You can change all the labels except Antenna (or
Cable) and MediaSmart. Use the OSD Setup menu to
change the label in the source list; see "Changing the
input labels" on page 80.

Selecting the last source

Press the Last Source button on the remote control to
change the input source to the last viewed source.

Adjusting the Volume

To increase or decrease the sound level, press:
The remote control Volume buttons.
Or
The TV Volume buttons.
The indicator bar on the TV shows the increase or
decrease in volume.

Muting the sound

1
Press the Mute button on the remote control to
temporarily turn off the sound.
2
Press the Mute button again to restore the sound
back to the previous level.