Setting The Standby Mode; Returning To Default Settings - HP MediaSmart SL4782N Guía Del Usario

To change an input label by using the remote control:
1
Press the Settings button to open the OSD. The
available menus appear as a list.
2
Press the Down Arrow button to highlight the
Setup menu, and then press the OK button.
3
Press the Down Arrow button to move within the
menu and highlight the Input Labels option, and
then press OK to move into the option.
4
Press the Down Arrow button to highlight the input
source that you want to change, and then press
the Right Arrow button. Press the Down Arrow
button to select the new label, and then press OK
to enter the change.
5
When you are finished, press the Settings button
to close the OSD.

Setting the Standby Mode

You can use the Standby Mode option to set the TV
mode for standby:
Fast Start: Starts quickly from standby.
Power Saver: Power consumption is low while
on standby, conserving energy.
n
The default TV Standby Mode is Fast Start.
To save electricity, change the Standby
Mode option to Power Saver.

Returning to Default Settings

You can use the Default Settings menu to return all
settings, including the input labels, to the default value.
Select Default Settings, and then press the OK
button.
This option does not reset the channels in the Fav list
and the channel list. These items are cleared only
when you run a new channel scan.
Changing the TV Settings
81