On/Off Button - Clatronic AR 735 CD/MP3 Instrucciones De Servicio

7. When installing your radio please ensure that there is
enough space at the rear of the radio to ensure suffi cient
cooling.
8. For the antenna connection there are two different norms.
The fi rst of these is the old (50 ohm) version with a long pro-
truding round contact on the vehicle and a round socket on
the radio end. The second is the ISO-standardised antenna
plug (150 ohm). Adapters for both formats are available from
accessory manufacturers and/or your car workshop.
NOTE:
Important information for VW/Audi vehicles: The active an-
tenna requires voltage on the shielding of the antenna coaxial
cable, without which reception is unsatisfactory. An antenna
adapter with phantom power supply will solve this problem.
Operating Instructions
1. If the front control panel is removed while the radio or CD is
on, the device is automatically switched off.
2. If the interior of the vehicle becomes very hot, for example
after standing in direct sunlight for a prolonged period, do
not switch on the player until the inside of the vehicle has
cooled down a little after you have been driving for a few
minutes.
3. In order to keep the removable control panel in a safe place
you should always use the protective case provided.
4. Playback of CDs produced by the user cannot be guar-
anteed due to the large variety of software and CD media
available.
Operation
1. Button
Press the button to remove the front operating panel.
2. +/- Button (Volume)
During normal playback these buttons are used to set the
volume.
If the SEL button is pressed beforehand, changes can be
made in the menus, e.g. sound mode.
3. SEL Button (Select)
a) Press the SEL button briefl y to access the sound mode
selection menu. The letters „VOL" appear in the display
for setting the volume. By repeatedly pressing the SEL
button you can now select the individual menu items
such as VOL (Volume), BASS (Bass), TRE (Treble),
BAL L-R (Balance) and FAD F-R (Fade). The settings of
the individual menu items are changed using the „+" or
„-" button.
NOTE:
If equaliser settings such as POP and ROCK have
been selected under USER SET it is not possible to
adjust the BASS and TRE.
b) Press the SEL button for a longer time to access the
selection menu:
05-AR 735 CD.indd 55 05-AR 735 CD.indd 55
• BEEP ON / BEEP OFF
• USER SET / FLAT / CLASSIC / ROCK / POP
• VOL LAST / VOL DEFA
Repeatedly pressing of the SEL button now brings up the
individual menu items. The settings of the individual menu
items are changed using the „+" or „-" button.
• BEEP ON/BEEP OFF (Confi rmation Beep)
Switch the confi rmation tone for when a button is
pressed on and off.
BEEP ON: The confi rmation beep is heard whenever
a button is pressed.
BEEP OFF: The confi rmation beep is switched off.
• USER SET (Equalizer)
In USER SET mode you can select the equaliser set-
tings FLAT, CLASSIC, ROCK and POP. Select USER
SET to carry out your own adjustments. See also
section 3a.
• VOL LAST/VOL DEFA
VOL LAST: The radio switches on at the actual vol-
ume it had when it was last switched off.
VOL DEFA: The following menu item now appears
when the SEL button is pressed again:
AVOL: Using the + and - buttons you can
pre-select a constant switch-on
volume.
• CLK ON/CLK OFF
CLK ON: The time is shown in standby mode.
CLK OFF: The time is not shown in standby mode.
• CLK 24/12
Choose between the 24 hour and 12 hour display mode.
NOTE:
The following appears in the case of the 12 hour
display
AM = in the morning, PM = in the afternoon/evening.
4.

On/Off Button

Press this button to switch the device on. WELCOME ap-
pears in the display. Keep this button pressed to switch the
device off.
5. MOD Button (MODE)
Press this button to select the CD player or radio mode.
6. BND Button
a) Radio Operation
Press the BND button briefl y in order to switch between
the FM levels and MW (medium wave). The designation
of the corresponding level FM or MW appears in the
LCD display.
55
17.10.2008 12:36:36 Uhr 17.10.2008 12:36:36 Uhr