Setup Procedures - Bovie AARON 800 - EU Guia Del Usuario

SETUP PROCEDURES

1. Mount the Aaron High Frequency Desiccator on the wall or optional mobile stand using the standard mounting
kit (see figure 1). Do not operate the unit in the horizontal position, as liquids may spill into unit.
Figure 2
2. Plug the female end of the power cord into the base of the unit (see figure 2, letter A).
3. Plug the male end of the power cord into a grounded wall receptacle.
4. Plug the handpiece into the monopolar output on the lower left of the front on the unit (see figure 2, letter B).
The plug is designed to fit in only one direction. Plug the smaller round connector from the handpiece (A900 only)
into the receptacle on the bottom of the unit (see figure 2, letter B). The three button handpiece is designed to give
the doctor complete fingertip control of the power output settings.
5. Slide the standard electrode into the handpiece until it is firmly seated (see figure 2, letter C).
The handpiece will accept most standard
6. Slide the handpiece from above into the holder on the right side of the unit.
7. Turn the unit power on utilizing the switch on the right side panel of the unit (see figure 2, letter D).
8. Set the power output either by using the dial on the front of the unit (see figure 2, letter E) or on Aaron 900 unit
only by the up and down buttons on the handpiece (see figure 2, letter J). When power level adjustment is being
made by the handpiece an audible tone will sound to indicate that the power level has been changed. Depressing
and holding the up or down buttons will cause the power settings to change more rapidly for quick adjustment of the
output settings. Power output is displayed in ".1" watt increments below 10 watts and in whole numbers from 10 to
30 watts.
NOTICE:
The output settings can not be adjusted when the unit is being activated.
User's Guide • Aaron 800-EU / 900
3 / " electrodes.
32
5