Steam Ironing; Filling The Water Reservoir - T-Fal FV92 Series Instrucciones De Uso

Warning ! Remove the soleplate protector before heating up the iron
Warning !
Prior to first use of your iron using steam on fabric, we recommend that you turn it on for a few seconds in the
horizontal position, and press the Burst of Steam button several times.
During the first few uses, the iron may give off an odor and smoke; both are harmless.This will not affect the
use of the iron and will quickly disappear.
What water to use ?
Your appliance has been designed to function with tap water. However, it is necessary to use the Auto-Cleaning feature to
clean the steam chamber regularly in order to eliminate hard water deposits. If your water is very hard you may mix tap water
with demineralized water in the following proportions : 50% tap water, 50% demineralized water.
What water not to use :
Heat concentrates the elements contained in water during evaporation.The types of water listed below contain organic waste
or mineral elements that can cause spitting, brown staining, or premature wear of the appliance: water from clothes dryers,
scented or softened water, water from refrigerators, batteries, or air conditioners, pure distilled water, or rain water. Do not
use any de-scaling agents in your iron, you may do permanent damage to the unit.

1- STEAM IRONING

Filling the water reservoir

- Unplug your iron before filling it.
- Set the steam control to DRY (A)
- Take the iron in one hand and tilt it slightly, soleplate downwards (D).
- To open the water tank stopper, turn it anticlockwise until the arrow
on the stopper points to the "open padlock" symbol (B). It will lift automatically.
- Fill the tank up to the "MAX" line (D).
- Re-close the tank stopper (C).To close the stopper, align the arrow with
the "open padlock" symbol then turn it clockwise until the arrow is aligned
with the "closed padlock" symbol.
- You can now plug in your iron.
Choose your ironing program
Your iron has 8 ironing programs:
• For each program corresponding to a type of textile to be ironed, your iron automatically and precisely
determines the most suitable temperature and steam flow to guarantee best results.
• To select the appropriate ironing program, use the program selector beneath the grip (E).
- Pressing on the left side
Beyond program 1, pressing the program selector has no effect.
- Pressing on the right side
Beyond program 8, pressing the program selector has no effect.
- The program selected appears automatically on the indicator panel at the front of the iron (F).
- Set the steam control to steam (
- When your iron reaches the required temperature, the thermostat indicator goes out (G).
You can start ironing.
(depending on the model).
.
: selects the programs requiring low temperature and steam levels.
: selects the programs requiring high temperature and steam levels.
)
2
1
A
2
1
C
E
ENG
B
D
F
G