Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOT FV32XX FTC 036635
Use
Filling the water tank
• Unplug your iron before filling it and set the steam control lever to
fig.1
(
).
• Open the water tank filling inlet lid (
position and fill it with water (
• Close the water tank filling inlet lid.
- It is normal for the
temperature indicator light to
turn on and off during ironing.
- In order to avoid water leaking
from the soleplate onto your
garment:
Set the steam lever to
•
when ironing silk or synthetic
fabrics and set it to
wool.
Should you need to turn
•
down the temperature, wait
until the temperature light
comes back on before
beginning to iron again.
- When ironing fabrics with
mixed fabrics, set the iron
temperature for the most
delicate fabric.
- For delicate fabrics, we
recommend testing the fabric
first on an inconspicious place
for example, (inside the hem).
- If you want to iron without
steam, set the steam control
lever to
.
Obtaining more steam
Burst of Steam
• Press the
fig.7
wrinkles (
).
Vertical steam function
This is ideal for removing wrinkles in delicate garments, jackets, skirts,
curtains, etc.:
• Hang the garment on a hanger and hold the fabric slightly taut with
one hand.
4
5/12/06
11:39
Page 4
fig.2
), place the iron in a horizontal
fig.3
).
Adjusting the temperature and the steam
• Adjust the temperature (see table below) by turning the temperature
control dial to the temperature select position (
• When the iron is plugged in, the temperature control light will remain
"on" until the temperature is reached. Once the temperature is reached,
it will go "off" (
• Adjust the amount of continuous steam output by moving the steam
fig.6
control lever (
levels.
for
F
ABRIC
L
INEN
C
OTTON
W
OOL
S
ILK
S
YNTHETIC
(Polyester, Acetate,
Acrylic, Polyamid)
• Your iron heats up quickly, therefore, begin ironing with fabrics that are
ironed at lower temperatures first, then go on to those requiring a
higher temperature.
button
periodically to remove stubborn
Spray button
• The
fabrics. Use this to remove stubborn wrinkles.
(depending on model)
Do not exceed the "MAX" fill
level as indicated on the water
tank of the iron.
fig.5
).
). See below table for recommended steam output
P
OSITION OF
TEMPERATURE BUTTON
MAX
•••
••
•
In order to achieve the
maximum amount of steam, it is
recommended that you wait a
few seconds after you push the
burst of steam button again.
fig.8
(
) will release a mist of water onto your
Every fifth time you press the
button, return the iron to the
horizontal position.
fig. 4
).
S
TEAM SETTING
POSITION
=
STEAM ZONE
Spray Function
Publicidad
Tabla de contenido
