Textron Jacobsen Eclipse 2 118 Manual Tecnico página 21

Display
Gen-Set Power Module - Used to indicate the gen-set power module is installed on the mower.
This setting is used by system controllers and does not affect operation of mower. Do not
operate mower with incorrect power module setting. Press the black button (J) to toggle
between the power module settings.
Battery Power Module - Used to indicate the battery power module is installed on the mower.
This setting is used by system controllers and does not affect operation of mower. Do not
operate mower with incorrect power module setting. Press the black button (J) to toggle
between the power module settings.
Set Number of Reel Blades: To set the number of reel blades, press either of the orange
buttons (K or L) on the front cover until the reel blades screen is on the LCD display. Press the
black button (J) to enter set mode. Use the orange buttons to set the number of blades.
Available reel blades are 7, 9 (Floating Only), 11 or 15.
Speed Paddle Calibration - Before calibrating the speed paddle, check that paddle stops are
properly adjusted [See Section 6.3].To calibrate the paddle, press either of the orange buttons
(K or L) on the front cover until the speed paddle calibration screen is on the LCD display. Press
the black button (J) to enter set mode. Move the speed paddle through its entire range of
movement to determine minimum and maximum values.
Values displayed will change as controls are moved.
Bail Lever Calibration - To calibrate the bail lever, press either of the orange buttons (K or L) on
the front cover until the bail lever calibration screen is on the LCD display. Press the black button
(J) to enter set mode. Fully engage and disengage the bail lever to determine minimum and
maximum values.
Values displayed will change as controls are moved.
Display Units - To set the display units, press either of the orange buttons (K or L) on the front
cover until the units screen is on the LCD display. Press the black button (J) to toggle between
english (MPH, IN) or metric (KPH, mm) units.
Factory Reset - To reset controller to factory default values, press either of the orange buttons
(K or L) on the front cover until the Factory Reset screen is on the LCD display. Press the black
button (J) to move to the confirm reset screen. Press the right orange button (K) to confirm reset,
or press left orange button (L) to cancel reset.
Maximum Mow Speed......3.4 Mph (5.5 kph)
Reel Speed ......................2200 rpm
Fixed FOC Setting............0.146
Display units.....................English
Description
CONTROLS
en-21
4