Trouble Shooting - HOLZMANN MASCHINEN HOB 260NL Manual De Instrucciones

16

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start or
shuts down automatically
during idling
Machine stops during
operation
Machine vibrates during
operation
Workpiece clamps during
thicknessing
Bad surface condition after
operating
Rough surface after operating
Cracked surface after
operating
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 Power supply outage
 Damaged or incorrect
connected extension cable
 Damaged switch or motor
 Blunt blade
 Feeding speed to high
 Motor protection triggered
 Wrong adjusted blade
 Ground not flat or base feet
wrong adjusted
 Cutting depth to high
 Dirty thicknessing table
 Blunt blade
 Uneven feed of the workpiece
 Workpiece too moist
 Workpiece was processed
against the direction of growth
 Cutting depth to high
www.holzmann-maschinen.at
Check fuse of the power

supply
Check plug or extension cable

Contact customer support

Check blade

Work with lower feeding

speed
Let the motor cool down

Check the setting of the

blades
Set the base feet correct

Set the correct cutting depth

and operate in more steps
Clean and apply the table

surface with lubricant
Check blade

Feed workpiece evenly and

with constant pressure
Use drier workpiece

Proceed the workpiece in

opposite direction
Set the correct cutting depth

and operate in more steps
N O T I C E
TROUBLE SHOOTING
Solution
52
HOB 260NL