Access Doors - Briggs & Stratton 01938-0 Manual De Instalación Y Arranque Rápido

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
Figure 3 — Location of Lifting Holes
To lift:
Insert
pipe
here
CAUTION!
during movement, which may cause injury.
WARNING!
used, be careful not to touch any overhead power
lines.
Figure 4 — Enclosure Access Doors
Door Lock
Screw
30"
Briggs & Stratton Power Products Home Generator
Installer-supplied pipe
The unit may shift on the lifting pipes
If lifting or hoisting equipment is
42"
www.mymowerparts.com
Installation Manual
You may also lift the unit using a "hook and hoist" method
attached to the lifting pipes, provided that you use a
spreader bar to ensure that the chains or cables do not
touch the generator's roof.
Retouch any chipped paint with supplied touch-up paint.
After paint is dry, and the unit is in place, fill the lifting holes
with the supplied lifting hole plugs.

Access Doors

The Home Standby Generator is equipped with an
enclosure that has four access doors (Figure 4).The doors
are named for a significant component located behind
them. Starting with the side that has the fuel connection
and proceeding clockwise, the doors are named:
• Oil Service door
• Air Intake door
• Control Panel door
• Battery door
Each Home Standby Generator is equipped with three
identical keys.These keys fit the locks that secure the Oil
Service and Control Panel doors.
DO NOT operate the Home Standby Generator unless
the Oil Service and/or Control Panel doors are installed.
• Failure to install Oil Service and/or Control Panel doors while
operating the Home Standby Generator will cause overheating.
Exhaust
Port
Fuel
Inlet
Door
Lock
Screw
6
CAUTION
29"