Install Pet Door; Train Your Pet - Petsafe SmartDoor PPA11-10711 Guía Para El Usuario

Step

Install Pet Door

4
fl ap) inside the cut out and check the fi t. Then, place the exterior frame into the
underside of the door to check the fi t. If frames do not fi t inside the opening, you
may need to recut to square opening before proceeding with installation.
4
Insert Screws
Step
5
5
Step

Train Your Pet

6
6
Before putting away the jigsaw, place the interior frame (frame with the
www.petsafe.net
4 Re-hang door and place interior frame with
fl ap inside cut-out of interior door. Place exterior
frame on exterior of door and press fi rmly against
interior frame and exterior frame with both hands.
Continue to press while moving hands from bottom
to top of frames until alignment tabs connect and
both frames are fi rmly in place.
Helpful Tip: Use painters' tape across SmartDoor
interior frame and door to keep in place while
positioning the exterior frame.
5 Thread mounting screws through interior
frame and align with exterior frame. Tighten with
screwdriver. DO NOT OVERTIGHTEN.
Helpful Tip: If using an electric screwdriver, set on
low torque.
NOTE:
Small SmartDoor
placement holes and Large SmartDoor
screw placement holes.
6 Tape the fl ap open to help your pet become
familiar with the pet door opening. When your pet
is more comfortable let the fl ap down and operate
the SmartDoor in UNLOCKED Mode encouraging
™
your pet to push through the fl ap. Once your
pet is comfortable entering and exiting through
the closed fl ap, set SmartDoor
Mode and operate with your pet's programmed
SmartKey . Walk your pet up to the SmartDoor
™
until the SmartKey
™
Repeat training your pet to walk up to SmartDoor
and push open fl ap to the other side.
Helpful Tip: Try treats to encourage your pet to
push through the SmartDoor
™
has four screw
™
to AUTOMATIC
™
is detected and fl ap unlocks.
fl ap.
™
's
™
has eight
™
™
9