Installation; Operation; Stand-By Button - Sunoptic Surgical LED-3000 Manual Del Operador

5. INSTALLATION

5.1 SETTING UP THE LED LIGHT SOURCE
Place the LED light source on a stable surface (cart, counter, stand, etc.).
NOTE Avoid places where the light source may be splashed with liquid.
Absolutely DO NOT use in any environment with explosive or flammable
DO NOT block the venting grids of the light source or impede exhaust air flow. Users
must ensure that ventilation air temperatures are below the maximum rating for the
light source and are not influenced by warm exhaust from other sources.
Make sure the power switch is in OFF position.
Connect AC power cord to the power inlet located on the rear panel of the light source.
Use only cords provided with the light source.
CAUTION
Plug the AC power cord into a wall outlet.
To prevent electric shock, connect power cords of peripheral equipment through
medical isolation transformers.
CAUTION
NOTE When using medical isolation transformer, be sure to check the transformer power
ratings.Make sure that the power cord is connected to the main power with three-
prong plug (USA use UL2601-1 rated isolation transformers and/or power strips
only).
5.2 CONNECTING THE FIBER OPTIC CABLE
Connect the light cable to the instrument and then plug the light cable end fitting into the turret
port on the front panel.
The turret has a cable in place sensing feature that will not allow the LED light to turn
NOTE
on without a fiberoptic cable inserted into the turret port.

6. OPERATION

6.1 POWERING UP THE LED LIGHT SOURCE
To operate the LED light source:
Turn on the power switch, the indicator light in the power switch will light.

6.2 STAND-BY BUTTON

The stand-by button will allow the user to turn the light on or off when the main power switch is on
provided a light tip is inserted in the active port.
Press AND HOLD this button momentarily for operation.
6.3 LIGHT INTENSITY CONTROL AND DISPLAY
The light intensity is adjustable enabling the user to obtain a brighter or dimmer output by pressing and
holding or repeatedly pressing the up or down arrow buttons until the desired illumination is reached.
There is an illuminated vertical bar graph LCD display for visual reference to the amount of light
intensity. Each lit segment represents 10% of the available intensity.
LIT-195 Sunoptic Surgical
Rev. F
®
Page 10 of 111
gases.
(English)