SECTION 6
6.0 Replacement Parts
6.1 General
Always provide the serial number of the unit on which the parts will be used. The serial number is stamped on
the unit nameplate.
6.2 Ordering
To ensure proper operation, it is recommended that only genuine ESAB parts and products be used with this
equipment. The use of non-ESAB parts may void your warranty.
Replacement parts may be ordered from your ESAB Distributor.
Be sure to indicate any special shipping instructions when ordering replacement parts.
Refer to the Communications Guide located on the back page of this manual for a list of customer service phone
numbers.
The ESP-150 is designed and tested in accordance with the international and European standards EN
60974-1 and EN 60974-10. It is the obligation of the service unit which has carried out the service or
repair work to make sure that the product still conforms to the said standard. Repair and electrical work
should be performed by an authorized ESAB serviceman. Use only ESAB original spare and wear parts.
Spare parts may be ordered through your nearest ESAB dealer, see the last page of this publication.
X
Schematics and Wiring Diagrams are printed on
279.4mm x 431.8mm (11" x 17") paper and are included
Bill of Material item numbers enclosed by a square denote sub-assemblies.
Refer to Bill of Material to identify items that make up the sub-assembly.
Sub-assemblies may be ordered instead of ordering each item individually.
inside the back cover of this manual.
NOTE:
Note
39 39
REPLACEMENT PARTS