Comfort Adjustments; Armrest Width Adjustment; Seat Height Adjustment - Pride TRAVEL SCOOTER Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TILLER ANGLE ADJUSTMENT (See fi gure 17)
WARNING! Remove the key from the key switch
before adjusting the tiller or the seat. Never
attempt to adjust the tiller or the seat while the
Travel Scooter is in motion.
WARNING! Prior to operating the scooter, push
and pull on the tiller to ensure that the angle
adjustment mechanism is secure. Inspect the
tiller adjustment knob and the angle adjustment
mechanism to ensure that they are fully
engaged.
check to make sure that the tiller adjustment
knob is fully tightened.
NOTE: In order to fully lower the tiller, you must fi rst remove
the seat and battery pack. Remove the seat by pulling it straight
up and off of the Travel Scooter.
SEAT ROTATION ADJUSTMENT
The seat rotation lever, located on the right side of the seat base,
secures the seat into several positions. See fi gure 18.
1. Pull up on the seat rotation lever to disengage the seat.
2. Rotate the seat to the desired position.
3. Release the lever to secure the seat into place.

ARMREST WIDTH ADJUSTMENT

The armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs. See fi gure 18.
2. Use the attached ring to pull and remove the detent pins.
3. Slide the armrests in or out to the desired width.
4. Align the adjustment holes on the seat frame and armrest,
then reinsert the detent pins.
5. Tighten the armrest adjustment knobs.
NOTE: Pivot the armrests upward to aid in getting onto and
off of your Travel Scooter.

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to different heights. See fi gure 19.
1. Remove the seat and battery pack from your Travel Scooter.
2. Use the attached ring to pull and remove the detent pin from
the lower seat post.
3. Raise or lower the upper seat post to the desired seat height.
4. While holding the upper seat post at that height, align the
adjustment holes of the upper and lower seat posts.
5. Fully insert the detent pin.
6. Replace the battery pack and seat.
Travel Scooter Series
V. C O M F O R T A D J U S T M E N T S
If there is movement in the tiller,
Figure 17. Tiller Adjustment Knob
IDENTIFICATION KEY
1.
Armrest Adjustment Knobs
2.
Detent Pins
3.
Seat Rotation Lever
2
Figure 18. Seat Adjustments
IDENTIFICATION KEY
1.
Upper Seat Post
2.
Lower Seat Post
3.
Detent Pin
Figure 19. Seat Height Adjustment
3
1
1
2
3
21

Publicidad

Tabla de contenido
loading

Tabla de contenido