Basic Troubleshooting - Pride TRAVEL SCOOTER Serie Manual De Instrucciones

V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic beep code will sound in the event one of the conditions listed below develops. Depending
on the model you own, your Travel Scooter will communicate by one of the coding methods as follows:
1. A beep code will begin with a series of fast beeps directly followed by slower beeps which indicates the actual
code. The beep code is only beeped once. To repeat the beep code, remove the key, then reinsert it and turn it
to the "on" position, OR
2. A beep code will identify the condition, pause, then repeat the beep code. The beep code will continue to alert
you in this manner until the scooter is turned off.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel Scooter has
been turned off, then turned back on.
BEEP CODE
■
(1)
■■
(2)
■■■
(3)
■■■■
(4)
■■■■■
(5)
■■■■■■
(6)
■■■■■■■
(7)
■■■■■■■■
(8)
■■■■■■■■■
(9)
What if my Travel Scooter does not move when I press the throttle control lever?
 When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/
transaxle assembly is cut.
 Pull back on the manual freewheel lever, turn the Travel Scooter off, and then back on to return to normal
operation.
26
CONDITION
Battery voltage is too low to operate the
Travel Scooter.
Battery charge is too low.
The Travel Scooter's battery voltage is too high
to operate the scooter, or the charger is still
connected to the off-board charger port.
Current limit time out.
The manual freewheel lever is in the (forward)
freewheel position.
Throttle control lever not at center position at
start up.
Speed pot error.
Motor volts error.
Other internal errors.
SOLUTION
Charge batteries as soon as possible.
Charge batteries.
Unplug charger and/or turn key off, then back on
again. If traveling down a slope, reduce Travel
Scooter speed to the minimum setting.
Turn the Travel Scooter off for a few minutes,
then turn your Travel Scooter back on.
Remove the key from the key switch, then
push the manual freewheel lever to the drive
(rearward) position and restart your Travel
Scooter.
Verify that the batteries are fully charged. If
the batteries are fully charged, then return the
throttle control lever to center position, turn
Travel Scooter off then back on.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Travel Scooter Series