Technical Data - Pentair Raychem RAYSTAT-ECO-10 Manual Del Usuario

DESCRIPTION
RAYSTAT-ECO-10 is an electronic controller with display, advanced alarm
facilities and the capability of switching large currents.
The RAYSTAT-ECO-10 is designed to control heating cable systems.
Heating cable can be controlled either directly by the RAYSTAT-ECO-10 or
via a contactor.
Direct switching of heating cables is possible for heating loads up to 25 A.
For heating loads greater than 25 A indirect switching via a suitably rated
contactor controlled by a RAYSTAT-ECO-10 is necessary. Installation and
all wiring must be in accordance with applicable regulations. The device
must be installed in non hazardous areas only. Thermal Management
offers other controls for use in hazardous areas.

Technical data

Supply voltage:
Main relay:
Heater operation on
sensor error:
Set point T range:
Accuracy:
Operatingtemperature:
User interface:
Power terminals:
Alarm terminals:
Sensor terminals:
Heater terminals:
Enclosure
Exposure Temperature:
Ingress Protection:
Entries:
Size:
Weight:
Material:
Mounting:
6
230 Vac. +10%/–10%, 50/60 Hz
(6V leakproof maintenance-free non-
rechargeable battery incl. for programming
without power supply)
max. 25 A, 250 Vac. Resistive
programmable: ON or OFF
0°C to + 30°C
±0,5 K at 5°C
–30°C (–20°C, VDE approved) to +40°C
ambient
4 x 7 segment digital display
4 push buttons
alarm relay, max. 2 A, 250 Vac.
(Potential free)
3 x 0,75 mm² to 4 mm²
(3 + ) x 0,75 mm² to 2,5 m²
(3 + ) x 0,75 mm² to 2,5 mm²
(2 + ) x 0,75 mm² to 4 mm²
–40°C to +80°C
IP 65
2 x M25, 1 x M20, 1 x M16
120 x 160 x 90 mm
approx. 800 gr.
polycarbonate
on a wall or directly on the pipe using
support brackets, SB-100 / SB-101