Main Applications - Cepra 5300 Manual De Instrucciones

Manual 5300.qxd 18/06/04 11:29 Página 36
Chronothermostat 5300
INSTALLATION
Warnings:
The crono-thermostat must be installed by skilled per-
sonnel according to the valid law. You must look for a
place with a representative temperature in the room you
want to control, far from heat sources, air flows or the
direct influence of the solar radiation or heating systems.
Before making any connection, make sure that you have
switched the central power supply off.
Assembly:
• Open the front cover to get to the inside part of the
crono-thermostat.
• In the lower part, there is another cover for the bat-
tery holder.
• Open that cover, pressing on the symbol
ding it to the right.
• Remove the batteries if you have already installed
them.
• Unscrew the screw
• Remove the cover by pulling outwards. This way you
will get to the connection terminals and to the holes
for the assembly.
• Fix the frame to the wall or to the machinery case
with the screws and slabs supplied.
• Fix the base of the crono-thermostat to the frame
with the screw.
• Make the electrical connection depending on the
appliance. Make sure that the cables are the proper
ones.
• Put the front cover of the crono-thermostat. Put the
screws again and place the batteries in their correct
position.
• Put the cover for the battery holder and switch the
central power supply on.
When you connect the crono-thermostat it makes an
auto-check-up of the segments of the screen and then
the screen starts flashing. by pressing any key the screen
will be stabilized and you can proceed programming
according to the instructions given below.

MAIN APPLICATIONS

and sli-
3 3 6 6