Tabla de contenido
Publicidad
SYMPTOM
• POWER lamp does not illuminate
when ON/OFF switch is in the ON I
position.
• Rollers do not turn with power lamp on.
• Laminated items exhibit curling.
• Laminated items exhibit wrinkles.
• Adhesive deposited on heat shoe.
• Unsatisfactory adhesion of laminate.
SERVICE AGREEMENT
GBC's Equipment Maintenance Agreement will insure the quality performance and long life built into your laminator.
A service charge for travel time, labor and parts may be incurred for each out of warranty service call. GBC's Equipment
Maintenance Agreement decreases these expenses and protects your valuable investment. GBC offers several types of
agreements to suit your needs and budget. To contact GBC write to:
GBC NATIONAL SERVICE
ONE GBC PLAZA
NORTHBROOK, IL 60062 U.S.A.
1/847-272-3700
POSSIBLE CAUSE
Laminator not connected to
electrical supply.
Circuit breaker open.
Feed tray interlock pin not in place.
Tension between the top and
bottom film roll is unequal.
Tension on top or bottom roll of
film is too loose.
Speed setting too slow.
Bottom film roll may be improperly
loaded.
Top and bottom film webs not
aligned.
Film improperly loaded.
Speed setting too fast for type of
material being laminated.
Insufficient heat.
Laminate improperly loaded.
Heat shoes require cleaning.
Laminated item unsuitable for
adhesion.
TROUBLE-SHOOTING GUIDE
CORRECTIVE ACTION
Insert attachment plug into receptacle.
Reset circuit breaker.
Slide interlock lever all the way into the left side frame.
Adjust tension per section FILM TENSION ADJUSTMENT.
Adjust tension per section FILM TENSION ADJUSTMENT.
Slightly speed up laminator.
Make sure bottom roll of film is around idler bar.
Align film webs per section FILM ALIGNMENT PROCEDURE.
Adhesive (matte) side of laminate film may be against the heat
shoes. Load film per procedure outlined in section
FILM LOADED & THREADING.
Lower speed setting by turning the speed control dial counter-
clockwise.
READY LCD lamp must be illuminated.
Adhesive side of film must be facing away from the heat shoes.
Bottom roll of film not threaded behind the idle bar.
Clean heat shoes with a soft, damp cloth.
Item may be dirty or may have non-porous surface that is
extremely difficult to laminate.
IN CANADA: GBC NATIONAL SERVICE
49 RAILSIDE ROAD
DON MILLS, ONTARIO
M3A 1B3
17
Publicidad
Tabla de contenido
