DeWalt DW802 Manual De Instrucciones página 9

CAUTION: Hold the side handle and body of the tool firmly to
maintain control of the tool at start up and during use and until the
wheel or accessory stops rotating. Make sure the wheel has come
to a complete stop before laying the tool down.
PADDLE SWITCH
To turn the tool on, push the lock-off
lever (B) toward the back of the tool,
then depress the paddle switch (A).
The tool will run while the switch is
depressed. Turn the tool off by
releasing the paddle switch.
WARNING: Do not disable the lock-off lever. If the lock-off lever
is disabled, the tool may start unexpectedly when it is laid down.
LOCK-ON BUTTON
The lock-on button offers increased comfort
in extended use applications. To lock the tool
on, push the lock-off lever (B) toward the
back of the tool then depress the paddle
switch (A). With the tool running, depress the
lock-on button (F). The tool will continue to
run after the paddle switch is released. To
unlock the tool, depress and release the pad-
dle switch. This will cause the tool to stop.
CAUTION: Allow the tool to reach full speed before touching
tool to the work surface. Lift the tool from the work surface before
turning the tool off.
SPINDLE LOCK
The spindle lock pin is provided to prevent the spindle from rotating
when installing or removing wheels. Operate the spindle lock pin
only when the tool is turned off, unplugged from the power supply,
and has come to a complete stop. Do not engage the spindle lock
while the tool is operating because damage to the tool will result. To
engage the lock, depress the spindle lock button and rotate the
spindle until you are unable to rotate the spindle further.
Mounting and Using Depressed
Center Grinding Wheels and
Sanding Flap Discs
MOUNTING AND REMOVING HUBBED WHEELS
adjustments or removing or installing attachments or acces-
A
B sories. Before reconnecting the tool, depress and release the
paddle switch to ensure that the tool is off.
Hubbed wheels install directly on the 5/8"-11 threaded spindle.
1. Thread the wheel on the spindle by hand.
2. Depress the spindle lock button and use a wrench to tighten the
B
3. Reverse the above procedure to remove the wheel.
F
tool on may result in damage to the tool or the wheel.
MOUNTING NON-HUBBED WHEELS
adjustments or removing or installing attachments or acces-
sories. Before reconnecting the tool, depress and release the
paddle switch to ensure that the tool is off.
Depressed center Type 27 grinding wheels
must be used with included flanges. See
page 5 of this manual for more information.
1. Install the unthreaded backing flange (G)
7 7
CAUTION: Turn off and unplug the tool before making any
hub of the wheel.
CAUTION: Failure to properly seat the wheel before turning the
CAUTION: Turn off and unplug the tool before making any
on spindle (D) with the raised section (pilot)
against the wheel.
G
D