KOBE CH-122 Serie Instrucciones De Instalación Y Manual De Operación página 16

Duct Cover Installation
3. Mark the position of the duct cover-mounting bracket. Use reference E from Table 2 and
measurements on Page 22-23. Attach and secure duct cover-mounting bracket with two
screws (not provided). Refer to Figure 18. NOTE: Inner duct cover will cover the duct
cover-mounting bracket.
4. Use aluminum or steel pipe to connect the plastic exhaust on the hood to the ductwork
above. Use duct tape to make all joints secure and air tight.
Connect electrical wires. Refer to "Wiring to Power Supply" on Page 17.
5.
6. Slide the inner duct cover up 2 inches before sliding the entire duct cover onto the hood.
Refer to Figure 19.
7. Adjust the height of the inner duct cover to the duct cover-mounting bracket. Secure the
inner duct cover with two (4x8 mm) screws (provided) as shown in Figure 20.
8. Fasten outer duct cover to multi vent exhaust on the hood with four (4x8 mm) screws
(provided).
Figure 18
Attach Together
Figure 20
14
Figure 19