KOBE CH-122 Serie Instrucciones De Instalación Y Manual De Operación página 19

Ocultar thumbs Ver también para CH-122 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Duct Cover Installation
4.
Mark the position of the duct cover-mounting bracket. Use reference E from Table 2 for
references.
provided). Refer to Figure 27. NOTE: Inner duct cover will cover the mounting bracket.
Connect electrical wires. Refer to "Wiring to Power Supply" on Page 17.
5.
6.
Slide the inner duct cover up 2 inches before sliding the entire duct cover onto the hood.
Refer to Figure 28.
7.
Adjust the height of the inner duct cover to the duct cover-mounting bracket. Secure the
inner duct cover with two (4x8 mm) screws (provided) as shown in Figure 29.
8.
Fasten outer duct cover to multi vent exhaust on the hood with four (4x8 mm) screws
(provided).
Attach and secure duct cover-mounting bracket with two screws (not
Figure 27
Figure 29
Attach Together
17
Figure 28

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ch2230sqbCh2236sqbCh2230sqCh2236sq

Tabla de contenido