Important Safety Instructions - Dyson AB06 Guia De Instalacion

Important safety InstructIons

Before InstaLLInG or usInG tHIs unIt reaD aLL InstructIons
anD customary marKInGs In tHIs InstaLLatIon GuIDe anD tHe
oWner's manuaL
save tHese InstructIons
WarnInG
Installation work and electrical wiring must be done by qualified electrician(s) in accordance
with all federal, state and local laws and applicable codes and standards, including fire-rated
construction.
filter change should be carried out by a qualified electrician.
WarnInG
risk of electric shock! If casing is removed or handled improperly the internal components of the
unit may cause harm or become permanently damaged.
WarnInG
to reDuce tHe rIsK of fIre, eLectrIc sHocK, or InJury to persons,
oBserve tHe foLLoWInG:
Do not use any pressure WasHInG eQuIpment for cLeanInG on or
near tHIs unIt
Before InstaLLatIon
Before beginning any installation work you must confirm the following:
WIrInG
• Check that the electrical supply corresponds to that shown on the rating plate.
• The unit requires a 15 amp circuit breaker with a dedicated line and neutral.
• The unit must be grounded properly.
• When connecting the unit to the electricity supply use electrical wiring in accordance with all federal,
state and local laws and applicable codes and standards, including fire-rated construction
• Ensure that the conduit and wires are long enough to connect to the backplate and the terminal block.
safety
• Isolate the power before installation or service.
HandDryerSupply.com | 804-859-2498 | http://www.handdryersupply.com
HandDryerSupply.com | 804-859-2498 | http://www.handdryersupply.com
InstaLLatIon
• Make sure that the unit is installed in compliance with all building codes and/or regulations.
• The unit must be mounted on a flat vertical wall capable of supporting the full weight of the unit.
• Use hardware as specified in this installation guide.
• Ensure no pipe work (gas, water, air) or electrical cables, wires or ductwork are located directly behind
the drilling/mounting area.
• Dyson recommends the use of protective clothing, eyeware and materials when installing/repairing
as necessary.
• To avoid damage to the fascia surface during installation, store the fascia in the original pacakaging
until it is needed.
• Do no use sealant when affixing the unit to the wall.
• All metal parts in contact with this unit MUST be grounded, including any wall covering.
• To reduce the risk of fire or electric shock, do not use this appliance with any solid-state speed
control device.
LocatIon
• The unit is designed for dry, internal location only.
• Consult local and national accessibility codes and regulations for relevant installation guidelines.
Conformity and compliance is the responsibility of the installer.
• Ensure the required electrical supply is available for later connection.
• If the unit is to be installed in a location subject to ADA regulations the installer should verify with their
local governing entity to ensure that the unit is installed to ADA guidelines.
WarnInG
this unit contains substances known to the state of california to cause cancer, birth defects and
other reproductive harm. Wash hand after installation or repair of this unit.
Important
• Please refer to the Dyson Owner's manual for details of the limited warranty.
• Dyson will not be held liable for any damage to property or personal injury as a failure to comply with
the instructions contained herein
2