Operation
The TidalWave VSC can be operated via the buttons on the control panel or the remote.
Note: The remote control requires 2 AAA batteries (not included).
To turn the pump on, press the power
be displayed on the screen.
the flow. Each time the flow is adjusted, the level will be displayed for three seconds and
then will return to the main "time of day" display.
To turn the pump off press the
will be displayed.
power is restored, the VSC will start the pump at full power for three seconds and then
return to the previous setting.
Programming the VSC
The TidalWave VSC is equipped
with a time of day clock and an
START/STOP timer feature. The
clock and timer do not need to be
programmed to operate the VSC.
Programming the clock and timer
must be performed via the buttons
and display located on the VSC
control box. After ten seconds of
inactivity during any part of the
programming sequence the selection
will be entered and the VSC will exit
the program functions and return to
the main clock display.
Setting the Clock
Press and hold the set
The hour will begin to blink.
the hour. After you have selected the hour, press the
will begin to blink.
Setting the Timer
When you are satisfied with the Clock setting, press the
enter the timer features. A small ON will be displayed on the left of the screen and a
large OFF will be flashing in the center of the screen.
START timer is currently turned OFF.
4
Use the up
power button. The word OFF and a 00 flow level
The VSC will retain the flow setting when powered off. When
button for three seconds to enter the program functions.
SET
Use the up
Use the up
button. The word ON and the flow level will
and down
V A R I A B L E S P E E D C O N T R O L L E R
and down
set button and the minutes
SET
and down
buttons to select the minutes.
set button and you will
SET
buttons to control
SET
buttons to select
This indicates that the