Tomato & Fruit Strainer Assembly - Weston 82-0102-W Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TOMATO & FRUIT STRAINER ASSEMBLY
NOT INCLUDED WITH ALL GRINDERS.
WARNING! Before cleaning, assembling or disassembling the Grinder, make sure
it is turned "off" and disconnected from the power source. Test to make sure there is
no power to the Grinder by switching the Motor Unit "on" and "off."
NOTE: The Tomato & Fruit Strainer Attachment cannot be used with meat products.
1. Hold the Plastic Chute with the outlet tilted almost fully downward and the head
ring facing the Motor Unit (FIGURE 6).
2. Place the head ring over the round raised
face on the front of the Motor Unit. Position
the tabs on the head ring next to the slots in
the corresponding tabs extending from the
round face (FIGURE 7).
3. Rotate the Plastic Chute counterclockwise
until the tabs fit into the slots. The Plastic
Chute should now be firmly held in place.
When properly positioned, the outlet of the
Plastic Chute should dip slightly downward.
4. Make sure the round end of the Drive Shaft
is equipped with a metal washer, spring and
metal washer (in this order). Install the Plastic
Washer onto the round end of the Drive Shaft
Assembly (FIGURE 8).
5. Insert the white end of the Drive Shaft into the
corresponding slot in the Auger.
6. Insert the Auger/Drive Shaft assembly into
the Grinder Head.
7. Position the Screen over the Auger. Line
up the tabs on the Screen with the notches in
the Grinder Head. Hold the Screen in place.
FIGURE 8
Plastic
Stainless
Auger
Steel
Screen
Outlet End
Plastic
Chute
Drive
Shaft Assembly
Bushing
Set
Head Ring
Round, raised face on
the front of Motor Unit
Plastic
Chute
Tabs on
Motor Unit
Stomper
Tray
Grinder
Head
Reverse
Button
FIGURE 7
Head
Locking
Knob
Motor
Unit
FIGURE 6
Power
Switch
11

Publicidad

Tabla de contenido
loading

Tabla de contenido