Cleaning And Maintenance; Technical Specifications - Toolland TM82007 Manual Del Usuario

5.7 Sanding
The removing rate and sanding pattern are determined by the type of sanding
Pay particular attention to applying uniform sanding pressure. This increases the
working life of the sanding sheets. Intensifying the sanding pressure will not lead to
an increase of the sanding capacity, but to the increased wear of the machine and
For precise, on-the-spot sanding of edges, corners and hard-to-reach areas, it is
also possible to work only with the tip or an edge of the sanding sheet.
A sanding sheet that has been used for sanding metal should not be used for
Regularly brush down or vacuum the surface being sanded to ensure the sanding
5.8 Scraping
On soft surfaces like wood, work at a flat angle and apply only light pressure so that
6.

Cleaning and Maintenance

•
Keep the ventilation openings clear, clean and dust-free at all times.
•
If the device is running erratically or something unusual occurs during use, immediately switch off the
device and unplug from the mains. Inspect the device before using it again. Repair must only be carried out
by a qualified technician.
•
If the supply cord is damaged, it must be replaced by a qualified technician.
•
Wipe with a damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong
detergents.
•
Clean the device and accessories before storing.
Storing
•
Store the device, its accessories and this user manual in the original packaging.
•
Always store in a cool and dry place.
7.

Technical Specifications

power supply ....................................................................................... 230-240 V~, 50 Hz
power consumption ................................................................................................. 300 W
no-load speed ...................................................................................... 15000-23000 /min.
oscillating degree ....................................................................................................... 3.0
cable length ............................................................................................................... 2 m
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.toolland.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 23/01/2017
sheet, the preset oscillation rate and the applied pressure.
premature wear of the sanding sheet.
sanding other materials.
sheet is in direct contact with the surface.
For scraping, select a high speed setting.
the scraper does not cut into the surface.
TM82007
NOTE
NOTE
7 ©Velleman nv