Installation Of The Monitor - Extel WEVP 258 E Instrucciones De Uso

3. INSTALLATION
2
4
3
a. Installation of the oudoor station (camera)
1. Remove the two screw covers
screws.
2. Insert the plastic casing
3. Connect the cable as shown in the wiring diagram with the waterproof gasket
4. Screw the plate onto the inserted casing using the two screws
5. Put the two screw covers back.
Make sure that the camera lens is not pointing directly at the sun or at a reflective surface.
Seal the upper joint between the exterior plate and the wall with silicone
b. Installation of the monitor
1. Put the wall carrier
2. Connect the wires coming from the
roadside panel.
3. Connect the adaptor plug
back of the monitor (without
connecting it to the power supply).
4. Fix the monitor
carrier .
2
5. Check that the installation is
complete and connect the adaptor
to the power supply.
NB : if the power supply cable is cut, check the polarity (black wire and black wire with grey
edging).
5
3
6
2
using a small screwdriver lodged in the notch
2
taking care not to obstruct the plate fixation holes.
1
in place.
2
to the
3
to the wall
1
1
.
4
3
6
4
. Remove the two
3
in place.
6
2
1
4
.
5