Troubleshooting - ARIETE MultiCooker Manual De Instrucciones

EN
- All temperatures are fixed for the 10 existing programs, except for manual function.
- The interval of time changes according to recipe and food amount.
APPLIANCE CLEANING
ATTENTION: Make sure the appliance is off and unplugged before disassembling it.
- Use a clean and soft cloth only for cleaning the appliance body (C).
- All components may be washed using warm water and any kind of dish detergent. For cleaning
the valve, lift the edge and remove it (Fig. 8).
- Wash the container (L) with dish detergent and a sponge, and then rinse.
- At the end or in case the appliance is not used for some time, position the spoon (F) or the spatula
(E) in the proper support (D) (Fig. 9).
ATTENTION:
In order to make components cleaning easier, after use, let them immersed in warm water with
a little dish detergent for 10 minutes.
In case of deformation of the container or the non-stick coating is damaged, replace it with a
new one bought at the nearest dealer. Do not use pans or other similar products.
Do not clean the container using abrasive powder, steel wool, or nylon. Clean the pan using
a sponge. Do not slam or scrape it.

TROUBLESHOOTING

Problem
Rice not cooked in the pre-set time.
Cooking starts when enabling the time delay
timer.
When pressing the START button (2), the coo-
king function does not start.
Steam does not come out from the suitable
valve (A), but from other parts.
Acoustic signal emission during the cooking or
warm keeping mode.
Display (5) shows "E1", "E2", "E3", "E4", "E5".
Cause
START button (2) not pressed.
Timer set with a shorter time compared to the
required minimum cooking time.
START button (2) pressed with the keep warm
function active.
Lid seal (O) or container edge (L) deformed or
stuck food.
Sounds are caused by strong steam escaping
between the container (L) and the heating
plate. When such condition continues, such
components may be damaged, therefore it is
important to wipe them before use.
Immediately switch the appliance off and leave
it to cool. If the problem remains and the error
icon does not disappear, a heating circuit fai-
lure may have occurred; contact therefore the
Service Centre.
- 16 -