General Description - Masterflex C/L 77120-32 Manual De Operación

GENERAL DESCRIPTION

® ®
The MASTERFLEX C/L Pump System,
Figure 1, is enclosed in a plastic 1/4 DIN
Case. The enclosure allows panel mounting
using optional Mounting Brackets (see
Accessory Section). Rubber Feet, supplied
with the unit, can be attached to the bottom of
the Case for operating on a bench or other flat
surface.
The Pump System can accommodate two
tubes simultaneously for the 6 and 60 rpm
systems at controlled speeds as low as 1 rpm.
Tubing is held in place by spring-clip Tubing
Retainers. For a list of tubing sizes for use with
the Pump System, refer to Appendix A.
The latching Occlusion Bed allows quick
loading or changing of tubing. The Pump Head
Rotor contains six rollers for minimum
pulsation. All units operate from an External
DC Power Supply. The AC models are
supplied with a Universal Power Supply, which
provides a DC output for
connection to the Pump Drive.
The single-turn, adjustable Speed Control,
Figure 2, provides variable flow -operation.
The green PWR On indicator lights whenever
the pump is operating. The Power
On/Direction Switch turns power on when
either clockwise or counterclockwise pump
rotor direction is selected. The MAX Button
is used for priming and purging and operates
the pump at maximum speed while depressed.
4
®
Tubing
retainers
Figure 1. MASTERFLEX
Tubing
retainers
Figure 2. Pump — Front Panel
Bezel
Occlusion Bed
Latch
® ®
C/L Pump System
MAX
Occlusion Bed Latch: Press
down to release occlusion
bed for changing tubing
1/4 DIN Case
Mounting
Bracket
(not Supplied)
Universal
Power Supply
PWR On
Indicator
PWR
MAX: Press and hold to
prime or purge pump.
Speed Control: Provides
variable flow adjustment
Power On/Direction
Switch