Control Panel - Zanussi ZBF22450SA Manual De Instrucciones

• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-

Control panel

1
ON/OFF switch
1
Display
2
Function button
3
1. Door open alarm indicator
2. Positive or negative temperature indicator
3. Temperature indicator
4. Fast Freeze indicator
Switching on
After plugging the plug into the power outlet, if
the display is not illuminated, press ON/OFF-
switch, appliance on.
As soon as the appliance is turned on, the fol-
lowing signals will appear on the control panel:
26
ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, es-
pecially at the rear near the heat exchanger.
The materials used on this appliance marked by
the symbol
2
Temperature regulator
4
Display
1 2 3
• Positive or negative temperature indicator will
be positive, indicating that the temperature is
positive
• the Temperature indicator flashes, the back-
ground of the display is red and you will hear
a buzzer.
Press Function button and the buzzer will go off
(also see "Excessive temperature alarm" ).
Place the Temperature regulator in a middle
position, and the appliance will be set up to
provide the following temperature:
roughly -18°C in the freezer.
are recyclable.
3 4
4
www.zanussi.com