Zanussi ZBF22450SA Manual De Instrucciones página 32

1
Loosen the upper
pin and remove the
spacer.
2
Remove the upper
pin and the door.
3
Loosen the lower
pin.
Ventilation requirements
The airflow behind
the appliance must
be sufficient.
Installing the appliance
Caution! Make sure that the mains cable
can move freely.
Do the following steps:
x
x
1
If necessary cut the
adhesive sealing strip
and then apply it to the
appliance as shown in
figure.
32
On the opposite side:
1
Install the lower
pin.
2
Install the door.
3
Tighten the
spacer and the upper
pin.
5 cm
min. 200cm
2
min.
200cm 2
13mm
Ø 2,5
2
Drill the unit us-
ing a Ø 2.5 mm drill
(10 mm max. pene-
tration).
Fix the square fitting
to the appliance.
2
1
3
Install the appliance in
the niche.
Push the appliance in
the direction of the ar-
rows (1) until the up-
per gap cover stops
against the kitchen fur-
niture.
Push the appliance in
the direction of the ar-
rows (2) against the
cupboard on the op-
posite side of the
hinge.
I
I
5
Attach the appli-
ance to the niche with
4 screws.
4mm
44mm
4
Adjust the appli-
ance in the niche.
Make sure that the
distance between
the appliance and
the cupboard front-
edge is 44 mm.
The lower hinge
cover (in the acces-
sories bag) makes
sure that the dis-
tance between the
appliance and the
kitchen furniture is
correct.
Make sure that the
clearance between
the appliance and
the cupboard is 4
mm.
Open the door. Put
the lower hinge cov-
er in position.
6
Remove the cor-
rect part from the
hinge cover (E).
Make sure to re-
move the part DX, in
the case of right
hinge, SX in oppo-
site case.
www.zanussi.com