General Assembly Instructions - ArmorAll VAC-MATE AA155 Manual Del Usuario

1.5 gal / 5.7 l
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GENERAL ASSEMBLY INSTRUCTIONS

Estimated Assembly Time: 15 minutes
Tools Required for Assembly: Drill, Screwdriver
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig.4)
5. Your vacuum comes ready for dry vacuum cleaning with the supplied reusable cloth filter installed. (fig.5)
6. For wet vacuum cleaning, install the supplied foam filter. (fig.6) See page 10 for filter installation.
For your convenience this vacuum comes with a wall mounting support for storage.
IMPORTANT!
• Do not mount the rack over 5 feet from the floor.
• Do not screw the rack to drywall only. Secure the screws to a stud.
• Do not hang from or sit on the vacuum when on mounting rack.
• Do not use the vacuum while it is mounted on the wall mounting support.
• Empty the tank before mounting the vacuum on the wall.
7. Replace the power head back on the container. (fig.7)
8. Aligning the top section with the latches, and snap into place. (fig.8)
6

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido