Dry Vacuum Operation; Dry Vacuuming Operation - ArmorAll VAC-MATE AA155 Manual Del Usuario

9. Insert the hose into the vacuum port. (fig.9)
10. Choose the desired nozzle and insert onto the end of the hose. (fig.10)
11. Make sure the rack is level and mark the hole locations. Make1/8-inch diameter pilot hole in each
marked location. Align the two screw holes so that they are over a stud and secure the mounting
support to the wall stud with the two screws provided. (fig. 11)
12. Place the wet and dry vacuum cleaner into the support. (fig. 12)
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a double polarized plug (one with the blade wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not
change the plug in any way. Double insulation
power cord and grounded power supply system.

DRY VACUUM OPERATION

DRY VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED 'SAFETY
INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Make sure the filter is completely covering the filter cage against the power head. (fig.2) (Your Wet/Dry
Vac comes with the reusable cloth filter pre-installed, if not, see page 10 for installation instructions.)
3. Place the power head back on the container, and secure it by locking the latches. (fig.3 & 4)
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the larger end of the hose into the vacuum port on the power head. Push the desired nozzle onto
the free end of the hose. (fig.5 & 6)
5. Ensure the switch is in the 'O' OFF position before plugging into the power supply. (fig.7)
eliminates the need for the three wire grounded
7