Battery Recharging - MELICONI HP300 PROFESSIONAL Instrucciones De Uso

For normal use, it is suffi cient to turn the headphones on and off using only switch "A" located on the headphones
themselves.
The base station transmitter will turn off automatically after 4 minutes in the absence of an audio input signal (the RED
LED "I" on the base and GREEN LED "E" on the headphones will turn off).
When the headphones are not being used, replace them on the base, ensuring correct contact with the recharging
clips "H" (the transparent housings on the base will light up BLUE). This procedure will ensure you fi nd the headphones
charged the next time you wish to use them.
If the headphones are not used for long periods, you should remove the batteries and disconnect the AC power supply
unit from the mains.
CAUTION
- The RED LED "I" on the base should always be on during normal use. If it is off, this means that the audio input signal
to the transmitter is missing or insuffi cient – turn up the volume on your TV or other device until the light comes on.
To adjust the listening volume you should use the volume wheel "C" on the headphones and NOT the volume on the
TV or other device.
- If the GREEN light "E" does not come on when turning on the headphones or the audio reproduction is distorted, go to
the base station and press the "D" (auto scan) button to link the headset with the base.
With its batteries charged, the device will operate for at least 6 hours continuously.
To recharge the batteries, turn off the headphones and replace them on the base, ensuring correct contact with the
recharging clips "H" (the transparent housings on the base will light up BLUE).
Leaving the headphones charging on the base, even for days at a time, will not cause any problems.
WARNINGS:
- For safety reasons, the batteries supplied are of a special type. Never use other batteries to replace the supplied
batteries. If necessary, contact MELICONI technical support.
- When headphones are not being used, turn them off to avoid draining the batteries completely and potentially
damaging them.
- The batteries must be fully charged before you fi rst use the device. An initial 24 hour recharge is required to ensure
maximum life for the rechargeable batteries. Always ensure that the ON/OFF switch "A" on the headphones is in the
OFF position while recharging the batteries.
- Do not expose the batteries to excessive heat sources such as direct sunlight, fi re or similar.
CAUTION:
Always follow applicable legislation in disposing of the product, and the batteries in particular. Dispose of the batteries in
a battery recycling container in order to ensure they are safely disposed of without damaging the environment.
If the audio device you wish to use does not have a headphone output, or you wish the TV to continue to use its own
speaker while using the headphones (if this does not offer separate controls), try connecting the base audio cable to
other available audio outputs via an appropriate adapter (not included).
RCA connectors
Use an appropriate cable (RCA male / 3.5 mm stereo headphone female
JACK), as shown in the fi gure, to connect the base audio IN cable to the
device RCA audio OUTPUTS (RED and WHITE sockets).
BE SURE you have correctly identifi ed the red and white sockets labelled
"OUTPUT" and not "INPUT".
SCART
Obtain the adapter shown in the fi gure as well as the cable (RCA / JACK)
illustrated above.
Connect the adapter to the TV's SCART socket and then connect it to the
audio cable on the base using the cable (RCA / JACK).
If no audio signal is obtained, try adjusting the (IN / OUT) switch on the
adapter or using another SCART socket on the TV.
Libretto Istruzioni HP300 Professional 14x20 24_11_2017.indd 15 Libretto Istruzioni HP300 Professional 14x20 24_11_2017.indd 15
Use

Battery recharging

Alternative audio connections
15
24/11/17 17:48 24/11/17 17:48