Battery Recharging - MELICONI HP 200 Instrucciones De Uso

IMPORTANT: on certain TV models you must activate the headphones audio output in the MENU, and increase the
volume so that it is sufficient for the base audio input. When the input audio signal to the base is present and sufficient,
the red indicator S (signal) on the base switches on and remains on.
- Stay close to the base and switch on the headphones with the "A" (POWER) button. Check that the red indicator inside
switches on and wait for a few moments.
- Check that the GREEN indicator "C" on the left earpad of the headphones switches on. If it does not, press the
"AUTOSCAN" button to start the pairing with the base.
- Put the headphones on and adjust the volume with the volume wheel "B" until you achieve the desired audio.
If no sound comes from the headphones, or if the audio is distorted see the "TROUBLESHOOTING" chapter.
Use
For normal use simply switch the headphones on and off with the "A" POWER button on the headphones.
The base transmitter will switch off automatically after 4 minutes in the absence of an input audio signal.
When the headphones are not being used, switch them off and place them on the base for recharging, see the
"BATTERY RECHARGING" section.
If the headphones are not used for a long period of time, disconnect the AC power supply from the mains power supply.
IMPORTANT
- During normal use the "S" RED (SIGNAL) indicator must remain always on. When it is off, it means that the input
audio signal to the transmitter is low or missing. Therefore turn up the volume on the TV until the indicator switches on.
To adjust the listening volume use the volume wheel "B" on the headphones and NOT the volume on the TV.
- If the audio is disturbed or missing when the headphones are switched on, go to the base and press the "C" (auto scan)
button to link the headphones to the base, which is shown by the green indicator inside the "C" button switching on.

Battery recharging

With the batteries charged the device will operate for at least 8 hours.
To recharge the batteries, switch off the headphones and place them on the base, rotating the earpads. Pay attention to
the correct contact of the recharge spring "D", the green indicator "Q" (CHARGE) on the front of the base must be on. It
switches off when the batteries are charged.
Leaving the headphones charging on the base, even for several days, will not cause any problems.
WARNINGS:
- For safety reasons, the batteries supplied are of a special type. Never use other batteries to replace the batteries
supplied. If necessary, contact MELICONI technical support.
- When headphones are not being used, turn them off to avoid draining the batteries completely and potentially
damaging them.
- The batteries must be fully charged before you first use the device. Always ensure that the ON/OFF switch "A" POWER
on the headphones is OFF (red indicator inside off) while recharging the batteries.
Alternative audio connections
If the audio device that you wish to use does not have a headphone output, or if you want the TV to continue reproducing
audio from its speakers, use the RCA audio sockets on the TV (red and white "OUTPUT" socket). Connect the audio
cable of the base to the RCA audio outputs of the device with the adaptor cable (2xRCA male / 3.5-mm stereo female)
included in the package.
15