Stihl MF-MM Manual De Instrucciones página 15

English / USA
Mounting the New Deflector
5
7
7
: Push the deflector (5) on to the drive
tube. Line it up with the flange (6)
and push it home as far as stop.
: Tighten down the clamp screws (7)
firmly.
Mounting the Gearbox
1
2
1
: Push the gearbox (2) on to the drive
tube. Turn the gearbox back and
forth and then push it home as far as
stop.
: Line up the gearbox.
: Go to "Checking Position of
Gearbox".
14
Checking Position of Gearbox
6
To reduce risk of injury from MultiTool
rotating in the wrong direction, check
that position of gearbox is correct and
adjust if necessary.
The shaft (1) must be below the drive
tube (2) so that the MultiTool rotates in
the direction of the arrow (3).
Adjusting Position of Gearbox
: Loosen clamp screws on gearbox.
: Turn gearbox 180°.
: Line up the gearbox in the correct
position.
: Tighten down the two clamp screws
on the gearbox in the following
sequence:
– Tighten first screw moderately.
– Tighten second screw moderately.
– Tighten down first screw firmly.
– Tighten down second screw firmly.
MF-MM