Symbols And Safety Warnings; Main Components; Assembly (Explanations On How To Remove The Packaging And Assemble Detached Parts) - EMAK BV 250 Manual De Instrucciones

can stuck into twigs. Tie up and protect long hair
(example with foulards, caps, helmets, etc.).
Safety shoes having skid-proof sole and anti-
piercing insert.
Wear protective goggles or face screens!
Use protections against noises; for example
noise reduction ear guards or earplugs.
The use of protections for the ear requests
much more attention and caution, because the
perception of danger audio signals (screamings,
alarms, etc.) is limited.
Wear gloves that permit the maximum
absorption of vibrations.
2. SYMBOLS AND SAFETY WARNINGS (Fig.24)
1. Read operator's instruction book before
operating this machine.
2. Wear head, eye and ear protection.
WARNING - The blower may throw objects
3.
at high velocity that can ricochet and hit
the operator. This may cause serious eye
damage.
Type of machine: BLOWER.
4.
5. Guaranteed sound power level.
6. CE conformity marking.
7. Serial number.
8. Year of manufacture.
WARNING! Danger of finger amputation.
9.
10. WARNING! The surface can be hot!.
11. The blower operator must make sure that no
bystanders or animals come nearer than 35
feet (10 metres). Whenever several operators
are working in the same work area, they
should maintain a safe distance of at least 35
feet (10 metres) from one another.
12. Noise pressure level measured at 50 feet (15
metres) distance according to ANSI B175.2-
2012.
3. MAIN COMPONENTS (Fig.1)
1. Nozzle
2. Blower tube
3. Throttle trigger
4. Handle
5. Safety guard
6. Throttle limiter
STOP button
7.
8. Spark plug
9. Primer bulb
10. Choke lever
11. Air cleaner cover
12. Fuel tank cap
13. Fuel tank
14. Starting handle
15. Muffler
16. Tube securing screw
4. ASSEMBLY
The machine is supplied ready for use in the
blower version.
The kit, supplied separately as an optional
accessory, allows the machine to be used as a
vacuum / shredder (see chapter 12.).
Assembling the tubes
WARNING – When fitting the tube and
nozzle, the engine must be off.
1. Undo the screw (A, Fig.3), to be able to
insert the eyelet (C) of the pipe (B) into the
appropriate housing. Tighten the screw (A),
to lock the pipe (B).
2. To pull out the extension tube (D, Fig.2) from
inside the blower tube (B), twist the collar
(E) in the "padlock open" direction, and
the tube (C) can then be drawn out. Once
the extension is at the desired length, twist
the collar (E) back toward the
closed" position to lock the two tubes
together.
3. To increase the directional and power
characteristic of the stream of air, the nozzle
can be mounted (F, Fig.4). The nozzle must
be inserted on the extension pipe (D, Fig.2),
locking it in the two hooks (G, Fig.4).
WARNING: inside the extension pipe (D,
Fig.2) there is an anti-intrusion safety grid. It
is not possible to use the blower without the
GB
"padlock
21