Electrical Connection - S&P CB-2005 Manual De Instalación. Instrucciones De Uso

- Do not use the heater in rooms with explosive gas or while using inflammable
solvents or varnish or glues.
- If the cordset is damaged and you have to change it, do not do the job yoursel-
ves! Take the product to an after sales authorised repair centre or to a person with
similar skill and knowledge, in order to avoid any risk of danger.
- Do not use this heater close to showers, baths, swimming pools.
- The appliance must be positioned so that the plug is always accessible.
- The heater shall not be placed just under a wall socket.
- Do not mount the product on walls made from synthetic material.

ELECTRICAL CONNECTION

- Only use the heater if it has been mounted on the wall in a vertical position;
- This heater is fitted with a double electrical insulation circuit (class II) and there-
fore does not require an earth connection.
- This heater is water resistant to IPX4. It can therefore be used in bathrooms or
other areas subject to humidity AS LONG AS IT IS NOT INSTALLED WITHIN THE
PERIMETER OF BATH TUBS OR SHOWERS. This means that it cannot be insta-
lled in the areas marked as VOLUME 1 in figure 1.
- It must never be possible for people in the bath tub or shower to reach the
adjustment knob.
- The disconnection devices of the supply rating must enalble the complete dis-
connection in case of the category of overvoltage III.
- This heater must be correctly installed in compliance with the legislation in force
in the country of installation.
INSTALLATION
- For the version fitted with a towel rail, BEFORE MOUNTING THE FAN HEATER
ON THE WALL:
- Fit the towel rail into the holes underneath the product, figure 2.
- Insert and tighten the 4 (short) screws contained in the bag, figure 3.
- The mimimum distance from the floor reported in figure 4 (30cm) changes to
60cm.
- Mount the heater on the wall making sure to observe the minimum distances
from the ceiling, floor and other walls, as shown in figure 4.
- Drill three 6 mm diameter holes in the wall, as shown in figure 5.
- Insert the three wall plugs supplied with the product.
- Insert the 2 upper screws, contained in the same bag, taking care to leave a dis-
tance of 8 mm between the head of the screws and the wall.
- Gripping the heater firmly, hook it onto the two screws; CAUTION! Before rele-
asing the heater make sure it is attached to the 2 screws.
- Then secure the product with the lower screw, figure 6.
10