Eu Declaration Of Conformity - WALTHER PILOT GM 1030P Instrucciones De Servicio

VERSION 12/2020
OPERATING MANUAL
15 EC/EU-DECLARATION OF CONFORMITY
EC/EU-Declaration of Conformity
according to 2006/42/EC, Annex II, No. 1A
We, the manufacturers of the equipment, hereby declare under our sole responsibility that
the product(s) described below conform to the essential safety requirements. This decla-
ration will be rendered invalid if any changes are made to the equipment without prior
consultation with us.
Manufacturer
Type Designation
Intended purpose
Applied Standards and Directives
EU-Mechanical Engineering Directives
2006/42/EC
2014/34/EU (ATEX Directives)
DIN EN ISO 12100:2011-3
DIN EN 1953:2013
Specification according 2014/34/EU
Category 2
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is prohibited
until such time as the end product has been proved to conform to the provision of the Directives
2006/42/EC.
Wuppertal the 11th August 2020
Name: Ralf Mosbacher
Managing Director
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
DOC2422648
WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Manual Spray Gun
PILOT GM 1030P ADH
PILOT GM 1030P
Processing of sprayable media
Part marking
DIN EN 1127-1:2019
DIN EN ISO 80079-36:2016
II 2G Ex h IIC T6 Gb
Name: Torsten Bröker
Manager, Design and Development
PILOT GM 1030P
V1030Pxxxx3
GM103xxxx3
Tech. File, Ref.:
2421
52