Installation Conditions; Installation And Connection; Typical Airspray Spraying System; Ventilation Of The Spray Booth - WALTHER PILOT GM 1030P Instrucciones De Servicio

VERSION 12/2020
OPERATING MANUAL
6.3

INSTALLATION CONDITIONS

The air temperature at the installation site must be in a range between 5 °C and 40 °C
(41 °F and 104 °F).
The relative air humidity at the installation site must be between 10 and 95% (without
condensation).
6.4

INSTALLATION AND CONNECTION

The Airspray manual gun PILOT GM 1030P must be supplemented with various components
to make up a spraying system. The system shown in the figure is only one example of
an Airspray spraying system. Your WALTHER distributor would be happy to assist you in
creating a spraying system solution that meets your individual needs.
You must familiarize yourself with the operating manuals and the safety regulations of all
additional system components before starting commissioning.

6.4.1 TYPICAL AIRSPRAY SPRAYING SYSTEM

Designation
A Airspray spray gun
B Air hose, electrically conductive
C Protective hose
D Product hose

6.4.2 VENTILATION OF THE SPRAY BOOTH

Operate the device in a spray booth approved for the working materials.
- or -
Operate the device on an appropriate spraying wall with the ventilation (extraction)
switched on.
Observe national and local regulations for the exhaust air speed.
DOC2422648
Designation
E Return line
F Product pump
G Pressure regulator
H Suction system
PILOT GM 1030P
20