Adjusting The Spray Pattern - WALTHER PILOT GM 1030P Instrucciones De Servicio

VERSION 12/2020
OPERATING MANUAL
7.3

ADJUSTING THE SPRAY PATTERN

Desired spraying result
B_06976
Rectifying defects in a spray pattern
Spray pattern
B_06981
Note:
The flow rate can be changed by:
– Changing the product pressure or limiting the needle stroke.
– Use of another nozzle (see Chapter
DOC2422648
Deviation
Spray pattern is too wide
in the middle
Spray pattern is too wide
on the ends
Spray pattern has very
coarse droplet distribution
Material application is very
thin in the middle of the
spray pattern
The spray pattern is
divided in the middle
Spray patter is too round
10.9 and 13.2).
Required setting
– Set a wider spray shape
– Set a rounder spray shape
– Increase the atomizing air pressure
– Reduce the atomizing air pressure
– Increase the nozzle diameter
– Reduce the atomizing air pressure
– Increase the product pressure
– Reduce product pressure
– Increase the atomizing air pressure
PILOT GM 1030P
24